IEEE

IEEE 1703-2012

IEEE Standard for Local Area Network/Wide Area Network (LAN/WAN) Node Communication Protocol to Complement the Utility Industry End Device Data Tables

IEEE 1703-2012

IEEE Standard for Local Area Network/Wide Area Network (LAN/WAN) Node Communication Protocol to Complement the Utility Industry End Device Data Tables

Действует

Дата ввода
29.06.2012
Дата утверждения
Тип Цена
Электронная версия ( PDF ) По запросу
Печатная копия По запросу
Redline - Электронная версия ( PDF ) По запросу
Redline - Печатная копия По запросу

Наименования

IEEE 1703-2012 IEEE Standard for Local Area Network/Wide Area Network (LAN/WAN) Node Communication Protocol to Complement the Utility Industry End Device Data Tables

IEEE 1703-2012 Стандарт IEEE для локальной сети / глобальной сети (LAN / WAN) Node Communication Protocol для комплемента коммунального хозяйства End устройств Таблицы данных

Утверждено

Информация отсутствует

Область применения

In the “Protocol Specification for ANSI Type 2 Optical Port” Standard (ANSI C12.18/MC12.18/IEEE 1701), a point-to-point protocol was developed to transport table data over an optical connection. The ANSI C12.18 / MC12.18/IEEE 1701 protocol include an application language called Protocol Specification for Electric Metering (PSEM) that allows applications to read and write Tables. The “Protocol Specification for Telephone Modem Communication” (ANSI C12.21/MC12.18/IEEE 1702) was then developed to allow devices to use PSEM to transport Tables over telephone modems. This standard extends the concepts of ANSI C12.18/MC12.18/IEEE 1701, ANSI C12.21/MC12.18/IEEE 1702, and ANSI C12.19/MC12.19/ IEEE 1377 standards to allow transport of Table data over any reliable networking communications system. Note that in this use of the word, “reliable” means that for every message sent, the sender receives a response at its option: either a positive acknowledgment or an error message. That is, messages cannot fail silently in a reliable network (see discussion of Reliable Stream Transport Service in IPPA [B1]).2 In addition, this standard describes an optionally exposed point-to-point interface between a C12.22 Device and a C12.22 Communicat

Разделы

[7] IEEE-SASB Coordinating Committees

Изменения

Информация отсутствует

Основополагающие документы

Информация отсутствует

Документ заменяют

Информация отсутствует

Документ заменил

Информация отсутствует

Основополагающие документы

Информация отсутствует