IEEE

IEEE 1453.1-2012

IEEE Guide--Adoption of IEC/TR 61000-3-7:2008, Electromagnetic compatibility (EMC)--Limits--Assessment of emission limits for the connection of fluctuating installations to MV, HV and EHV power systems

IEEE 1453.1-2012

IEEE Guide--Adoption of IEC/TR 61000-3-7:2008, Electromagnetic compatibility (EMC)--Limits--Assessment of emission limits for the connection of fluctuating installations to MV, HV and EHV power systems

Действует

Дата ввода
06.07.2012
Дата утверждения
Тип Цена
Электронная версия ( PDF ) 135.00
Печатная копия 168.00
Redline - Электронная версия ( PDF ) По запросу
Redline - Печатная копия По запросу

Наименования

IEEE 1453.1-2012 IEEE Guide--Adoption of IEC/TR 61000-3-7:2008, Electromagnetic compatibility (EMC)--Limits--Assessment of emission limits for the connection of fluctuating installations to MV, HV and EHV power systems

IEEE 1453.1-2012 IEEE Guide - Принятие IEC / TR 61000-3-7: 2008 Электромагнитная совместимость (ЭМС) - Пределы - оценка предельно допустимые выбросы для подключения колеблющихся установок для MV, HV и СВНЫ энергосистем

Утверждено

Информация отсутствует

Область применения

This part of IEC 61000 provides guidance on principles which can be used as the basis fordetermining the requirements for the connection of fluctuating installations to MV, HV andEHV public power systems (LV installations are covered in other IEC documents). For thepurposes of this report, a fluctuating installation means an installation (which may be a load ora generator) that produces voltage flicker and / or rapid voltage changes. The primaryobjective is to provide guidance to system operators or owners on engineering practiceswhich will facilitate the provision of adequate service quality for all connected customers. Inaddressing installations, this document is not intended to replace equipment standards foremission limits.This report addresses the allocation of the capacity of the system to absorb disturbances. Itdoes not address how to mitigate disturbances, nor does it address how the capacity of thesystem can be increased.Since the guidelines outlined in this report are necessarily based on certain simplifyingassumptions, there is no guarantee that this approach will always provide the optimumsolution for all flicker situations. The recommended approach should be used with flexibilityand engineering judgment as far as engineering is concerned, when applying

Разделы

[4] IEEE Power and Energy Society

Изменения

Информация отсутствует

Основополагающие документы

Информация отсутствует

Документ заменяют

Информация отсутствует

Документ заменил

Информация отсутствует

Основополагающие документы

Информация отсутствует