IEEE

IEEE 3-1982

IEEE Recommended Practice in the Selection of Reference Ambient Conditions for Test Measurements of Electrical Apparatus

IEEE 3-1982

IEEE Recommended Practice in the Selection of Reference Ambient Conditions for Test Measurements of Electrical Apparatus


IEEE 3-1982

IEEE Рекомендуемой практики в выборе эталонных условий окружающей среды для испытаний измерений электрооборудования


Не действует

Дата ввода
08.06.1982
Дата утверждения
Тип Цена
Электронная версия ( PDF ) 75.00
Печатная копия По запросу
Redline - Электронная версия ( PDF ) По запросу
Redline - Печатная копия По запросу

Наименования

IEEE 3-1982 IEEE Recommended Practice in the Selection of Reference Ambient Conditions for Test Measurements of Electrical Apparatus

IEEE 3-1982 IEEE Рекомендуемой практики в выборе эталонных условий окружающей среды для испытаний измерений электрооборудования

Утверждено

Информация отсутствует

Область применения

In general test results and the performance of electrical apparatus are significantly influenced by variations in such parameters as temperature, barometric pressure, and humidity. A meaningful comparison of the results of two tests made under different ambient conditions is possible when the result of one of the tests is corrected or adjusted to indicate the results that would have been obtained if the ambient conditions for that test had been identical with those for the otherre.Especially in the situation where several tests performed under different conditions are to be compared, it is advantageous to select standard reference values for all pertinent parameters and then to correct or adjust the results of each test to indicate the results that would have been obtained if all tests had been performed under identical conditions, that is, under the reference ambient conditions.It is the purpose of this document to identify and recommended a set of standard reference values for certain ambient parameters which are significant in electrical test measurements.Even though agreed-upon correction factors may not be available, the ambient temperature, the barometric pressure, and the relative humidity should always be recorded and reported. In this way retesting will not be necessa

Разделы

IEEE [4] IEEE Power and Energy Society

Изменения

Информация отсутствует

Основополагающие документы

Информация отсутствует

Документ заменяют

Информация отсутствует

Документ заменил

Информация отсутствует

Основополагающие документы

Информация отсутствует